Description: This design (a RFM95W controlled by an Arduino Pro Mini) was my first step in the world of IoT.
The board is tested with the examples of the Matthijs Kooijman
LMIC library and works perfect.
It's also used in the IoT workshop
of the iot-usergroup.de.
A second set of PCB designs (power supply/sensor boards) are planned as piggyback/hat for this
iot_lora board. Power alternatives will be: solar cell, CR2032, 2 x AAA, supercap, TPS61291,
TPL5111 and/or TPS22860.
1 x RFM95w/868MHz
1 x Arduino Pro mini
2 x 10K (I2C pull up)
1 x SMA antenna connector
1 x pin header 2x7
ATTENTION: The update to V2.0: ADC6 and ADC7 (analog exclusively) are not connected
to JP3 anymore but PB0 and PB1 (possibility for soft serial). The HF part has now a switch to SMA
or spring antenna and added are GND planes on both sides.
ATTENTION: The update to V3.0: (on request) added a JST PH 2mm power connector
(for RAW and VCC) and a silkscreen update.
ATTENTION: The update to V4.0: added the footprint (SOP-8) for AT24CXX EEPROM to save TTN EUI's and Key's.License: CC-BY 4.0